© Copyright 2004 - 2020 MAD Design Group. All rights reserved. V1119
ENGLISH
Left Corner & Right Corner
Installation
5. Complete the construction by finishing the wall paneling around the
appliance. (See section on FINISHING INSTRUCTIONS and ensure that
you fully understand where non combustible materials must be used.)
6. Place the burner into position.
7. Remove the dust protective tape that covers the windscreen
mounting slots.
8. If your appliance includes a decorative box on the left / right or both,
insert the internal glass panel by feeding the glass upwards into the
slot then pushing down into the positioned clips.
*Decorative logs must NOT be placed directly over an open flame.
They are designed to sit near heat but not over flames.
9. Insert the full height glass panel into one of the open end side by
inserting the glass into the opening at the top of the appliance, and
lowering it into the slots in the base until it bottoms out into place.
10. Install the windscreen by inserting the glass ends into the slots. Use
a small amount of pressure to push the windscreen in place until it
bottoms out into the hidden glass clips.
WARNING: The glass used is toughened glass - which means it is
stronger than normal glass. Importantly, even though it is stronger,
toughened glass still has weaknesses. The corners and sides are
specific pressure points where it is more fragile and can break if care
is not taken. Glass breaks into many small pieces. Take care to avoid
cuts. We recommend you wear protective gloves when handling glass.
11.Spread the glass charcoal evenly around the appliance tray.
CAUTION: Make sure the burner lid is closed. Keep the glass
charcoal away from the burner flange to avoid glass charcoal from
accidentally going into the burner chamber. Be careful not to scratch
the burner.
