© Copyright 2004 - 2020 MAD Design Group. All rights reserved. V1119
ENGLISH
Double Sided
Installation
6. Remove the red stability bracket(s).
7. Complete the construction by finishing the wall paneling around the
appliance. (See section on FINISHING INSTRUCTIONS and ensure that
you fully understand where non combustible materials must be used.)
8. Place the burner into position.
9. Remove the dust protective tape that covers the windscreen
mounting slots.
10. If your appliance includes a decorative box on the left / right or
both, insert the internal glass panel by feeding the glass upwards
into the slot then pushing down into the positioned clips.
*Decorative logs must NOT be placed directly over an open flame.
They are designed to sit near heat but not over flames.
11. Install the windscreen by inserting the two ends into appropriate
slots in the appliance. Use a small amount of pressure to push the
windscreen in place until it bottoms out into the hidden glass clips.
Repeat the same for the back side windscreen.
WARNING: The glass used is toughened glass - which means it is
stronger than normal glass. Importantly, even though it is stronger,
toughened glass still has weaknesses. The corners and sides are
specific pressure points where it is more fragile and can break if care
is not taken. Glass breaks into many small pieces. Take care to avoid
cuts. We recommend you wear protective gloves when handling glass.
12. Spread the glass charcoal evenly around the appliance tray.
CAUTION: Make sure the burner lid is closed. Keep the glass
charcoal away from the burner flange to avoid glass charcoal from
accidentally going into the burner chamber. Be careful not to scratch
the burner.
