ECOFOREST Cantina Super, Installation And Maintenance Manual

Page: 224 / 263

223
If you activate this MENU when room temperature you settled goes beyond
2°C, the boiler will stop and turn on after room temperature would have gone
down and after the boiler gets cold. In order to activate it, press the increase
button (
V
) and you will see on the screen that it is activated by an “S”
between fuel level and room temperature.
Example: If you wish the temperature sensor (thermostat) to control the start and stop of the boiler through
room temperature, put the Stand-By by thermostat on position YES. This function is only recommended in case of
minimal temperature decrease in the house (2°C within 24 hours) as repeated starts and stops may damage the
boiler.
If you wish the boiler to turn on at a higher level than set by default, (level 5) change it at point 1-5 , to reach
this point, follow previous steps that is, press MENU (
Z
) twice and increase (
V
) until the following is displayed:
When this screen is displayed, press MENU ( Z ).
Programming has to be made through the increase/decrease buttons
(
C V ). Pellets drop level at which you wish the boiler to turn on (1, 3, 5, 7,
9). To exit, press On button ( X ), you get back to point 1-5 pellets level.
If you press On ( X ) you get back to the main screen and if you press increase ( V ) you enter menu 1-6
Combustion air adjustment.
Important: if you request a password to enter, this will be
V V V V V V V V V V V V V V V V V V V V V V V V V V V V V V V V
.
Though the boiler adjusts automatically, fine-tuning might be necessary, for
example, lack of cleaning, dirty heat exchanger, fire-basket full of ash, etc.
Setting is easy: when
point 1-6 is displayed, press MENU ( Z
)
and the
following appears:
Actual combustion air level in millibars, to adjust it, increase it through ( V ) or
decrease it through (
C
). This setting is necessary only in case of problems
related to gas outlet pipe or excessive drawing. It can be increased (+ 0.09) or
decreased (- 0.09) through 9 levels. To exit press On (
X ) and you get back to
point 1-6 Combustion air setting.
If you press MENU ( Z
)
:
In this menu, set the extractor rotation manually: by pressing
increase/decrease buttons (
C V
) you will increase or decrease the power
of the extractor – read point 1-7a air setting – carefully.
Only in air models. If you press MENU ( Z
)
:
In this menu, set the extractor rotation manually: by pressing
increase/decrease buttons (
C V ) you will increase or decrease the speed of
the convection fan.
If you press On ( X ) you get back to the MENU and if you press the increase button ( V ) you reach menu 1-7
Multiple use settings.
Press MENU ( Z ) and you reach this menu.
1-4c Thermostat
Standby NO
1-5 Pellets
level programming
1-5 5 _ _ _
level programming
1-6 Combustion
air adjustment
1-6a Air combus.
adjustm.
. 00 mB
1-6b Adjust turn
extract. 00%
1-6c Fan speed
adjustm. 00%
1-7 Other uses
programming