9
Installation (continued)
Top Cover
Plug into
Connector on
Electronic
Control Board
Feed Wire
through Slot
Optional
AC Adaptor
E. INSTALL THE BATTERY
1
. Take the included 9V battery out of its plastic wrap.
2
. Remove the top cover from the ASF by sliding it
upward (See Figure 12).
3
. Snap the battery connector onto both terminals of
the 9V battery.
4
. Place the connected battery into the clip provided
for it directly above the IN port (See Figure 12).
5
. Slide the top cover back onto the ASF and push it
down to snap into place.
F. OPTIONAL AC ADAPTOR (not included)
An optional AC adaptor (P/N 7302835) is available to
supply 9V DC power to the electronic control instead
of using a 9V battery. This adaptor has 5 feet of wire.
One end plugs into a household 120V AC, 60 Hz. out-
let and the other end plugs into the back of the elec-
tronic control board, as shown in Figure 13. See the
Repair Parts List page for ordering information.
IMPORTANT:
Do not use any AC adaptor other than
the EcoPure P/N 7302835 with this
Automatic Sediment Filter.
To install the optional AC adaptor:
1
. Remove the top cover from the ASF by sliding it
upward (See Figure 13).
2
. Remove any previously installed 9V battery from the
ASF (disconnect it from the battery connector and
lift it out of the clip above the IN port).
3
. Locate the small round plug on one end of the AC
adaptor cable and insert this into the connector on
back of the electronic control board (See Figure 13).
4
. Plug the other end of the AC adaptor into a 120V,
60 Hz household electric socket.
5
. Before replacing the cover on the ASF, feed the wire
through the small slot above the IN port of the ASF
(See Figure 13).
6
. Slide the top cover back onto the ASF, making sure
not to pinch any wires, and push it down to snap
into place.
Top Cover
9V Battery
Battery Connector
Clip
FIG. 12
FIG. 13
Plug into
Connector on
Electronic
Control Board
Top Cover
Battery Connector
Clip
9V Battery
Top Cover
Feed Wire
through Slot
Optional
AC Adaptor
