OPERATING INSTRUCTIONS.
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning
of this manual including all text under subheadings therein before set up or use of this
product.
Please do not knock any parts of the tool, otherwise it is
dangerous for the operator.
Do not put your fingers into the head of the tool during
operating. Your fingers could be pinched very severely.
1.
Retract the die and piston back to starting position by twisting handle clockwise.
Make sure the tool is under its original situation before operating.
2.
Insert cable fully into connector and then center it between dies.
3.
Pumping the handle, the three moveable dies will move toward and hold the connector
automatically. Be sure the connector was centered between dies. Keep pumping until a
significant sound was heard, it means we have finished one cycle of crimping.
4.
Press the active handle a little bit, twist the handle clockwise to release the pressure,
retract the die and piston.
5.
Take out cable when the die and piston retracted fully.
Please refer to the illustration below.
