Ecler WiSpeak TUBE, User Manual

Page: 72 / 79

72
• ID TEST SIGNAL button: clicking on it will start playing a test tone sequence in
the receiver unit. The sequence is stopped after 10 seconds, or pressing again the
same button. It is really useful to get an acoustic identification of a receiver
loudspeaker in an installation, for troubleshooting and/or adjusting purposes
The unit is available to active the ID test signal when the button is shown like this:
...and once activated, it shows this status, allowing clicking on it again to cancel
the current test tone signal:
•
UNPAIR FROM WiS NETWORK button: it allows to unpair one or all the
receivers currently linked to the transmitter. Successfully unpairing one receiver
will result in two actions:
o
The unit will disappear from the Loudspeakers page Paired Loudspeakers
list
o
The unit will be available to be paired again to a transmitter unit
Clicking on this button opens the following window:
And it allows to cancel the process, or to unpair the receiver unit currently under
control, or to unpair the whole set of receiver units included in the Paired
Loudspeakers list.
After a successful unpair process, the receiver unit gets back to its factory defaults,
including the default Alias and rest of parameters (volume, reception channel,
SOLO status, Ping Count).