14
8.
GROUP ID SELECTION
In multiple sources scenario, each VEO Transmitter can stream a video signal over
network using Group ID number that must be unique in the same network. Each Group
ID
from 0 to 63
identifies a multicast address and every VEO Receiver can “listen” one
of these channels. The Group ID for Transmitters is usually set once during the first
installation steps while the receivers ID can change in order to show different content
on the displays.
The Group ID can be selected in three different ways:
Using the IR Remote Control
Via Web browser
Using Telnet
8.1 Group ID and RS-232 baud rate selection using IR Remote Control
8.1.1. Group ID
The Group ID can be selected using the included IR remote control. Ensure that IR-Ext
sensor is connected (refer to 5.1). The remote control can be used to change Group ID or
RS-232 baud rate as explained below.
Press button
①
to switch between Group ID and baud rate function
When double-digit ID Group number is shown on the display, press “+” or “–” to
select Group ID.
Press the number keys to change Group ID. For example, if you need to change to
01, press “0”, and then press “1”.
Example:
