12
5.
Connect IR TX cable to “IR TX” port of the Transmitter; Connect IR RX cable into
“IR RX” port of the Receiver. Then you can control source at the RX side using IR.
6.
Connect RS-232 Cable from the PC or automation system to Transmitter RS-
232 port; connect RS-232 cable from the Receiver to RS-232 port of the device
to control.
7.
Power on Transmitter and Receiver with adapter 5V 1A.
8.
Ensure that the selected Group ID is the same for both devices.
7.3. Point-to-Multipoint Connection and Operation
1.
Set the IP address for Transmitter & Receiver and prepare the switch
2.
Follow steps as instructed above (refer to 6.1)
3.
Connect source device and VEO Transmitter with HDMI Cable.
4.
Connect HDMI looping output of the VEO Transmitter to a local HDMI display.
5.
Connect Transmitter to network switch/router using Cat5e or Cat6 cable.
6.
Connect all VEO Receivers and network switch/router using Cat5e/6 cables.
7.
Connect HDMI displays to the HDMI VEO Receiver units with HDMI
Cable.
8.
Connect IR TX cable to “IR TX” port of the transmitter; Connect IR
RX cable to “IR RX” port of the receiver. Then you can control source at the RX
side with IR.
9.
Connect RS-232 Cable from PC or automation system to the Transmitter RS-
232 port; connect RS-232 cable from the Receiver to RS-232 port of the device
to be controlled.
10.
Power on Transmitter and Receiver with adapter 5V 1A and power on
network switch. If switch supports PoE (Power over Ethernet), it will not be
necessary to power the VEO devices locally.
11.
Ensure that the selected Group ID is the same for Transmitters and Receivers.
