13
Illustrations are typical and may not match exact vehicle details
email - [email protected]
tel - 1-800-477-2267
Illustrations are typical and may not match exact vehicle details
email - [email protected]
tel - 1-800-477-2267
Cable Routing - (cont)
Step 3 - (cont)
Driver Door (LH):
The left hand door has
plugs in both locations on the body side
connector (3a). Remove the rubber grom-
met. Remove both connectors and cut a
groove for the camera harness to pass
through (3b). Then feed the harness as
explained for the RH door.
PLEASE NOTE
At this point, we do not recommend reassembling the vehicle until all cameras are installed and tested.
After confirming everything works, reassemble vehicle.
NOTE: Do not forget to fold mirrors and rein-
stall the T15 Torx screws in the bottom of the mirrors.
Step 4
Once inside the vehicle, route the camera
extension harnesses to your monitor, mak-
ing sure to avoid any moving parts. Secure
the harness using cable ties.
FCTP-DR1304
Lane Change Assistance - RAM Truck
3a
3b
