11
Illustrations are typical and may not match exact vehicle details
email - [email protected]
tel - 1-800-477-2267
Illustrations are typical and may not match exact vehicle details
email - [email protected]
tel - 1-800-477-2267
Camera & Mirror Assembly - (cont)
Step 4
Reinstall the front surround / top arm cover.
Then reinstall the new back cover, locking
both pieces together.
Reinstall the 3 x T20 Torx screws (4a).
Install the supplied Philips pan head screw
as indicated in photo (4b).
Step 5
To reinstall the mirror glass, reconnect any
electrical connectors. Position the mirror
glass assembly into the housing and seat
the lower hinge type clips (1) fully.
Push the top of the glass back into the
housing and seat the top mounting clips.
Step 6
Reinstall the mirror on the vehicle. Route
the factory mirror wire harness, along with
the side camera cable through the oblong
hole in the door (6a). Carefully align mount-
ing studs and lock top clip into place. While
still holding the mirror, hand tighten the 3
x 10mm nuts. Then fully tighten the 10mm
nuts from inside the vehicle.
FCTP-DR1304
Lane Change Assistance - RAM Truck
1
4b
4a
6a
