16
THROTTLE CABLE
1. Loosen the two lock nuts.
2. Adjust so that the throttle trigger is fully opened
when the throttle lever is gripped.
3. Adjust so that there is a gap between the throttle
trigger and the throttle plate when the throttle
lever is released.
4. Tighten the two lock nuts.
DEPTH ADJUSTMENT CABLE
1. Pull the cart handle forward.
2. Loosen the two lock nuts.
3. Move Depth adjustment lever to lock side and
free side to check the position where it operates.
4. Tighten the two lock nuts.
Throttle plate
Throttle trigger
MOVING THE CART
WARNING
• Remove the engine cut-off saw from the cart
before loading it onto the bed of a vehicle.
• If lifting the cart with the engine cut-off saw
mounted on it, do not lift it by the handle of
the engine cut-off saw.
• If the rear handle plate unlocks suddenly,
the cart may fall and cause an injury.
CAUTION
• If the throttle cable is not in the correct
position, the depth adjustment lock may
come unlocked.
1. When pushing the cart to move it, lift the cutting
wheel when going over different levels in the
surface to keep the cutting wheel from hitting
them.
2. Always stop the engine before moving the cart.
3. Pushing the handle forward makes the cart
smaller, which helps in loading it into a vehicle.
MAINTENANCE AND CARE
Cart handle
Lock nuts
Lock nuts
REAR HANDLE
1. If there is a gap in the grip of the rear handle,
loosen the bolt and then reduce the size of the
gap by pressing the rear handle plate down to
the rear handle.
Bolts
Rear handle
plate
Summary of Contents for CWT-7410
Page 19: ...19 NOTES ...
