Echo CWT-7410, Operator'S Manual

Page: 14 / 20

14
OPERATION
WARNING
• Before use, make sure functions such as
of the throttle lever, depth adjustment and
wheel break are working correctly.
• If any functions are not working properly,
contact the sales outlet for repairs.
• Remove any obstacles from the cutting
path.
• If the engine is started with the cutting
wheel on the ground, it may drive the cart
and cause an accident.
• When the engine is started in the latched
condition, wheel rotates at high speed at the
same time as the start. Immediately release
the latch by holding the throttle lever once.
• Always apply the wheel break when starting
the engine, and when not using the cut-off
saw.
CUTTING GUIDE
CAUTION
• Always use the water-flushing function
when using the cart for cutting.
• Use clean water for flushing the cut. If dirty
water is used, it will cause problems.
• If the cutting wheel is held locked while
cutting with the throttle fully open, it may
cause damage.
1. Apply the wheel brake on flat ground.
2. Loosen the handle lock knob and adjust the
height of the cart handle to an easy to use posi-
tion. Fully retighten the handle lock knob after
adjusting the height. (When doing so, make sure
the teeth of the tooth lock washers mate.)
3. Completely fill the water tank. The hose joint can
be disconnected and the water tank removed
and taken to a water tap to fill it.
*If water is put in the tank, but the hose joint is not
connected, water will leak from the hose joint, so
put the hose joint at a position higher than the
water level.
4. Before starting the engine, check and make sure
the depth adjustment indicator of the cart is on
parking position and that the cutting wheel is not
touching the ground.
5. Hold the front handle of the engine cut-off saw
and start the engine. Follow the instructions in
the operator’s manual of the engine cut-off saw
to start the engine. As soon as the engine starts,
take hold of the cart handle.
6. Open the liquid cock of the engine cut-off saw so
the water starts flowing. (Follow the instructions
in the operator’s manual of the engine cut-off
saw to operate the liquid cock.)
Cart handle
Handle lock
knob
Starter knob