9
6 INCH CHIPPER
ENGLISH
ASSEMBLY
2.6 ATTACH DIGITAL DISPLAY
CONTROLLER MOUNT ASSEMBLY
1. Remove the bolts (1) and nuts (2) attaching the digital
display controller mount assembly (3) to the inside of
the chute.
2. Attach mount assembly to the outside of the chute as
shown.
3. Route harness using the zip ties and two holders (4)
shown in Figure 2.6. Leave excess harness at the
controller to allow rotation of the enclosure from side
to side.
Figure 2.9, Digital Display Controller Enclosure
2
3
4
1
1. Attach one clamping ring (1) and one spacer ring (2)
to discharge tube base (3) using three 3/8 × 1-1/4"
bolts (4) and nylock nuts (5). Tighten leaving 1/16"
gap to assist in mounting to flange. See Figure 2.10.
2.
Slide the tube onto the mounting flange on the
chipper frame. The discharge clamp (1) should slide
underneath the lip of the flange. Tighten the bolts to
secure it.
3. Install the second half of the spacer (2) and clamp
ring (1) on the discharge tube with 3/8 × 1-1/4" bolts
(4) and nylock nuts (5).
2.7 ATTACH DISCHARGE TUBE
Figure 2.10, Attach Clamp Ring and Spacer
1
2
3
4
5
Figure 2.11, Attach Discharge Tube
1
2
4
5
6
4. Attach lanyard with discharge pin (6) as shown in
Figure 2.11. Loop on lanyard installed below nut
located under discharge handle.
5. Lubricate the chute by applying grease to the grease
zerk at the base of the chute. Rotate the chute and
apply grease until the chute rotates freely.
6. Rotate the tube 360 degrees and lock it in place with
the lock pin to make sure it is mounted correctly.
Keep nuts as tight as possible while allowing the
discharge tube to freely turn.
NOTE
The controller mount assembly can be attached to the
chute in either set of mounting holes.
NOTE