7
6 INCH CHIPPER
ENGLISH
ASSEMBLY
2.3 INSTALL REAR STABILIZER
The rear stabilizer is installed by sliding the stabilizer into
the trailer support guide on the rear of the chipper frame.
The stabilizer is secured and adjusted with the provided
snap pin.
Figure 2.6, Rear Stabilizer
11
10
9
Figure 2.3, Brake Rod Installation
Figure 2.4, Brake Rod Connection at Axle
9
14 15 12
13
Figure 2.5, Hitch Jack Mounting
16
17
18
19
7. Locate the brake control rod (9) and thread one M10
nut (10) about 4 cm on to the end of brake control
rod with the least amount of threading. Then thread
rod in to the brake clevis (11) located underneath the
coupler. (Do not tighten the M10 nut against the clevis
until final adjustments are made in later steps.)
8. Insert the other end of the brake control rod in to the
center hole of the balance bar bracket (12) at axle
location.
9. Next, insert the ends of the brake cable lines (13) in to
the outside holes of the balance bar bracket.
10. Secure the balance bar bracket to the brake rod by
threading the M10 × 35 mm spherical nut (14) on
to the brake rod making sure that the convex end
of the nut is toward the bracket. This nut will be the
adjustment point for setting brake tension.
11.
Adjust the length of the brake rod so there is no play
without any pre-load.
12.
Once proper brake adjustments are set, thread the
final M10 hex nut (15) on to the brake rod end and
tighten securely against the spherical nut to prevent
it from loosening,
13.
Place pivot jack (16) into position on the coupler
assembly mounting bracket.
14.
Align jack clamp bracket (17) over the jack and secure
to the coupler mounting bracket by vertically inserting
an M8 × 140mm bolt (18) through the holes. Add
nylock nut and tighten securely while still allowing
clamp to pivot.
15.
Secure jack at desired height by inserting threaded
handle (19) through clamp bracket, into threaded
hole of mounting bracket and tighten.
