8
6 INCH CHIPPER
ASSEMBLY
Figure 2.8, Chute Attachment
1
3
4
5
6
7
8
5
9
10
11
2
CE COMPLIANT
MODEL
USE OF A CERTIFIED HOIST OR OTHER LIFTING
DEVICE WILL BE NEEDED TO PROPERLY ALIGN
AND ATTACH CHIPPER CHUTE TO MACHINE.
IMPORTANT
2.4 ATTACH CHUTE AND SUPPORT
In tropical regions, areas of high humidity or rainfall
amounts, dielectric grease may be added to wire
harness connectors to provide corrosion resistance.
NOTE
2.5 ATTACH LICENSE PLATE LIGHT
1. Attach the license plate light to the chute support,
which is located under the feed chute, with two #10-
24 nuts and two #10-24 × 1/2 screws.
2. Plug the wire harness into the license plate light.
Figure 2.7, License Plate Light
CH611DH MODEL
CH611DHXE MODEL
1. Attach the feed chute (1) to the chipper body using
nine 3/8 × 1-1/4" carriage bolts (2) and nylock nuts.
For the two upper bolt locations, insert the bolts from
inside the feed roller housing. For the two lower bolt
locations, insert the bolts from inside the feed chute.
The other five bolts mount through the left and right
chute supports on the outer flanges of the feed roller
housing and feed chute. Install one 3/8 × 1-1/2"
carriage bolt (3), clamp (4) and nylock nut, as shown.
Do not tighten completely at this time.
2. Bolt the chute support (5) to the chipper frame with
two 3/8 × 1" carriage bolts (6) and nylock nuts. Install
one 1/2 × 1-1/2" bolt (8) and nylock nut.
3. Bolt the chute support to the feed chute at the hinge
location using one 3/8 × 1" hex bolt (7) and nylock
nut.
4. CE COMPLIANT MODELS ONLY:
Bolt the license
plate bracket (11) to the chute support using two 5/16
× 1" carriage bolts (9), and to the feed chute with two
5/16 × 3/4" carriage bolts (10) with nylock nuts for all
four.
5. Connect the wire coming from the feed chute to the
connector that is located underneath the chipper feed
roller. The wire harness should be routed through the
clamp referenced in step 1.
6. Now go back and tighten the bolts and nuts
attaching the feed chute to the housing.
