Page 3 of 8
Notes:
1. Larger wires and tight connections will provide longer service life for components. For high current wires it is highly recommended
that terminal blocks or soldered connections be used with shrink tubing to protect the connections. Do not use insulation displacement
connectors (e.g., 3M Scotchlock type connectors).
2. Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices to reduce voltage
drop. All wiring should conform to the minimum wire size and other recommendations of the manufacturer and be protected from moving
parts and hot surfaces. Looms, grommets, cable ties, and similar installation hardware should be used to anchor and protect all wiring.
3.
Fuses or circuit breakers should be located as close to the power takeoff points as possible and properly sized to protect the wiring and
devices.
4. Particular attention should be paid to the location and method of making electrical connections and splices to protect these points from
corrosion and loss of conductivity.
5. Ground termination should only be made to substantial chassis components, preferably directly to the vehicle battery.
6. Circuit breakers are very sensitive to high temperatures and will “false trip” when mounted in hot environments or operated close to their
capacity.
The wiring for the permanent mount lightbar is as shown in Figure 1. All wiring should be a minimum of 18AWG. The positive line must have
a 5 amp fuse, as shown. A switch may be used to control the on/off function.
Wiring Instructions:
+
-
5 A FUSE
(USER SUPPLIED)
SWITCH
(USER SUPPLIED)
SWITCH FOR DIM
RED
POSITIVE
BLUE
(+) DIM/(-) FLASH PATTERN SELECT
(ISOLATE WHEN NOT IN USE)
BLACK
GROUND
YELLOW
SYNC
(ISOLATE WHEN NOT IN USE)
+
-
5 A FUSE
(USER SUPPLIED)
SWITCH
(USER SUPPLIED)
SWITCH
(USER SUPPLIED)
RED
POSITIVE
(COLOR 1)
WHITE
POSITIVE
(COLOR 2)
BLACK
GROUND
YELLOW
SYNC
(ISOLATE WHEN NOT IN USE)
SINGLE COLOR
SERIES
DUAL COLOR
SERIES
SWITCH FOR DIM
BLUE
(+) DIM/(-) FLASH PATTERN SELECT
(ISOLATE WHEN NOT IN USE)
ON - COLOR 1
ON - COLOR 2 (DUAL
COLOR ONLY)
OFF
PATTERN SELECT
Figure 1
Figure 2
