31-7-2014 7 ebode IPV58P2P
1. I/O alarm terminal block (Not available for this camera)
This network camera provides a I/O alarm terminal block which is used to connect to
external input / output device. The pin(there are four number in the terminal block from
no. 1 to no. 4) definitions are as follows: 1.) input, 2). input, 3). output, 4). output.
This camera supports I/O alarm, you can go to Settings-Alarm - I/O page to configure it.
2. LAN
10/100M adaptive Ethernet interface. Through this interface, IPCAM can be connected
with various network devices, such as hub, router, etc.
3. Reset Button
Press and hold on the reset button for 5 seconds. Releasing the reset button, the
password will back to the factory default administrator password. The default
administrator user is admin with no password.
4. Power Interface
Connect the external power adapter, request for 12V/2A power.
5. Audio input interface
The jack is used to plug external input device such as sound pick up device directly. Here
microphone cannot directly insert to the interface, it must connect to commutator first.
6. Audio output interface.
The jack is used to plug external output device such as loud speaker directly. Here
microphone cannot directly insert to the interface, it must connect to commutator first.
7. RS486 Cradle head interface (Not available for this camera)
This camera supports the standard 485 cradle head protocol (Pelco-D and Pelco-P).
Please configure the RS485 protocol corresponding information first (go to Settings- PTZ
- RS485 Configuration page and do settings), or else the cradle head may cannot work.
Bottom View
There are up to three labels located at the bottom of the camera; this is an important
feature of original cameras. If your camera does not have labels as shown in Figure 3.3
and 3.4, it may be a clone. Cloned cameras cannot use original firmware and are not
eligible for warranty or technical services.
Figure 3.3