38
EATON XSTORAGE COMPACT INSTALLATION MANUAL
P-164000907 - March 2022 www.eaton.com
00 Title
1 X16 Battery 3 conn
2 X16 Battery 3 connection -
3 X15 Battery 2 conn
Tightening torque for the DC power terminals X15 and X16 is 22 Nm (35 – 95mm
2
).
3. Connect the CAN cables. For instructions, refer to Section 5.7
CAN cabling of internal battery packs.
a. If there is only one battery string in the external battery rack, the CAN cabling is as in the internal
battery string.
b. For CAN cabling in a rack with two battery strings, connect the Com IN and Com OUT cables
as in Figure
21: CAN cabling in the external battery rack with two battery strings.
c. Make sure that the small termination resistor switch is in the bottom position (resistor connected) in the
master battery pack of the external battery rack. Make sure that the small termination resistor switch is in
the top position (resistor not connected) in the master battery pack in the xStorage Compact unit.
d. For the master battery pack and battery pack addresses, see
Table 12: Master battery pack and battery pack
addresses (hexacode).
4 X15 Battery 2 connection -
5 X10 Battery breaker status signals
Figure 20 . Battery connection terminals
Table 11 . X10 Battery breaker status signals
Pin
X10 External battery cabinet breakers
1
CB2_STATE_11
2
CB2_STATE_14
3
CB2_UVR
4
CB2_UVR_0V
5
CB3_STATE_21
6
CB3_STATE_24
7
CB3_UVR
8
CB3_UVR_0V
