xComfort Room Controller Touch User Manual 1v00_EN
10 |
P a g e
2.6.2
(Optional)
Selecting Heating and/or Cooling mode
It is possible to select which temperature regulation mode should be active manually.
(OFF)
No icons displayed. No heating or cooling, e.g. regulation switch off.
Heating mode. Regulation based on heating set-point(s) temperature only.
Cooling mode. Regulation based on cooling set-point(s) temperature only.
Heating&Cooling mode. Regulation based on both heating and cooling set-points
temperature.
Sensor Mode
If the Room Controller is connected to an xComfort SHC, it is possible to change manually between
‘heating’, ‘cooling’ and ‘OFF’. In this case, the ‘Heating&Cooling’ mode is not available. When connected
to a Room Manager the temperature regulation mode cannot be changed.
Control Mode
* The available regulation modes depend on the configuration. If a heating or a cooling actuator is
connected only, then it is only possible to switch between ‘heating and OFF’ / ‘cooling and OFF’
manually. If both actuators are connected, then all modes are available.
Optional
Step 1
(Show mode)
Current active mode is shown
Step 2
(Select mode)
Control Mode*
(OFF)
Sensor Mode
(OFF)
Optional
Timeout