XS series operating manual
XS user manual v0.55
- 71 -
Dielectric strength test error messages
The following error messages may appear during the measurement:
(message) SAFETY LOOP
the safety loop is not closed. There is no connection between the points 1-9 and 2-10 of the C5
connector of the rear panel. Make the connection, press again on the [MEASUREMENT] green push
button to trigger the measurement mode.
(message) VOLTAGE ERROR
the test voltage has not reached its final value (impedance of the specimen under test too low), in DC
voltage wait for the end of the charge, in AC voltage check with the current specifications of the power
supply. In case of over heating a built-in thermal switch cuts off the high voltage generator.
Wait for 3-5 minutes before going on.
(message) I<IMIN
during the HOLD time, the leakage current flowing through the specimen under test has not reached
the minimum value set by the IMIN parameter (possible bad connection of the test probe). This fault
gives a bad (FAIL) test result even there is no breakdown.
(message) SYNCHRO ERROR
the dielectric strength test board is not able to generate the sinusoidal signal which drives the HV
transformer.
You cannot perform a test, get in contact with our Service department
(+33 1 64 11 83 48)
(message) BOARD NOT READY
the microprocessor board cannot communicate with the insulation resistance board.
You cannot perform a measurement, get in contact with our Service department
(+33 1 64 11 83 48)
