Configuring the System − Getting Started
Page 20
If the lid of the control unit is open, you will see:
14. If the standby screen is displayed, enter the installer menu (as described in the next
section). Otherwise, if the "Panel lid open" message is displayed, press
to access
the Installer menu.
15. Carry out the required configuration tasks in the Installer menu; for example, to:
Add the other keypads, if used (page 33).
Program zones.
Configure the auxiliary output (if used).
Configure setting options.
Entering the Installer menu
Entering the Installer menu allows you to configure the system using the options provided.
You cannot enter the Installer menu if the system is set.
While you are logged in:
The system will not generate alarms. You are, for example, able to open the lid of
the control unit without generating an alarm. All Hold-Up Alarms (HUAs), fire-alarm
zones, 24-hour zones and tampers are disabled.
Any other user trying to set the system from a keypad or access the user menu will
see the message “Installer on Site”.
To enter the Installer menu:
1.
Make sure the system is fully unset and showing the standby screen. For example:
2.
Enter the Installer code, as specified when the control unit was first configured:
Note:
Only one user can be logged in at any one time. If you or another user is
logged in at another keypad, you will see "System Busy".
3.
You may be prompted to enter a user code:
This is displayed if you have not used the Installer menu with the previous 30
minutes, or if the system has been armed and disarmed within that period. You can
disable this feature using
System Options
– User Options – User Access – User
Code Required
(see page 48). You cannot enter a Set Only user code.
4.
The bottom line displays
Detectors/Devices
, which is the first option in the menu:
Refer to the next section for details of how to use the user interface.
