SC300 Handbook
14
Copyright © 2007-2018 Eaton Corporation. All Rights Reserved.
IPN 997-00012-03 B2 Issue B2 July 2018
Display Settings
► To change the display contrast
•
Use the keypad to go to:
Settings
>
Setup
>
Contrast
>
Edit
.
► To change the display language
•
See Language Options on page 21.
► To change the display orientation (horizontal/vertical)
Either:
•
Use the keypad to go to:
Settings
>
Setup
>
Orientation
>
Edit
.
•
Select the required orientation (vertical, horizontal-left or horizontal-right). Press
Save.
Or:
•
In Web go to:
System
>
Interfaces> Physical Ports
> Front Panel
.
•
In DCTools, go to
Configuration > Communications > Front Panel > Physical Mounting.
•
Select the required orientation (vertical, horizontal-left or horizontal-right). Click
Apply.
The functions of the navigations keys also change to suit the new display orientation.
Main Screen Parameters
The parameters displayed on the SC300 main screen are configurable. Either two large or three
small parameters can be displayed. The default settings are two large parameters with the values
Bus Voltage
and
Rectifier Current
.
1.
Value 1
2.
Value 2
► To change the parameters displayed on the main screen
Either:
•
Use the keypad to go to:
Settings
>
Setup (tab)
>
Display Settings > Main Screen
Layout.
Or:
•
In Web go to:
System
>
Interfaces > Physical Ports
> Front Panel
.
•
In DCTools, go to
Configuration > Communications > Front Panel.
•
Set
Main Screen Layout
to
Two Large
or
Three Small.
•
Select the required parameters (see Note 1) for
Value 1
and
Value 2 (
and
Value 3
if
Three Small
is selected).
•
For each of
Value 1/2/
3
Units
, select
No Units
, e.g. Battery Temp. 25,
With Value
,
e.g. Battery Temp. 25°C, or
With Label
, e.g. Battery Temp. (°C) 25
.
•
If any of
Analog Input, Energy Meter, Power Meter, Current Meter, Voltage Meter or
Smart Analog
are selected as a display parameter, then also select a value for
Value 1/2/3 Index
. See Note 2.
