Eaton PowerXL DX-NET-SWD, Manual

Page: 7 / 69

0 About this Manual
0.1 Target group
DX-NET-SWD 06/13 MN04012009Z-EN www.eaton.com
3
0 About this Manual
In this manual, you will find the special information that you need to link a
SmartWire-DT interface card DX-NET-SWD3 with a variable frequency drive
of series DC1 and adapt it to its required settings with the aid of the parame-
ters. The information refers to the specified hard and software versions.
0.1 Target group
The content of MN04012009Z-EN manual is written for electrical engineers
and automation technicians. A specialist knowledge of electrical engineering
and fundamental technical principles is needed for commissioning. In addi-
tion you should be familiar with the handling of the SmartWire-DT system.
0.2 Further manuals for this device
Further information can be found in the following manuals:
On the topic “Variable frequency drive“
• „DC1 – MN04020003Z-EN
On “SmartWire-DT“
• “SmartWire-DT The system“ – MN05006002Z-EN
(previous designation AWB2723-1617en)
• “SmartWire-DT module“ – MN05006001Z-EN
(previous designation AWB2723-1613en)
• “SmartWire-DT Gateways“ – MN05013002Z-EN
(previous designation AWB2723-1612en)
0.3 Sources
[1] Profile Drive Technology, PROFIdrive Technical Specification for
PROFIBUS and PROFINET, Version 4.1, May 2006; Order No: 3.172
￫
The above mentioned manuals and further information can be
found in the internet:
http://www.eaton.com/moeller
￫ Support