Eaton PowerXL DX-NET-SWD, Manual

Page: 27 / 69

4 Commissioning
4.1 DX-NET-SWD3 with DC1 variable frequency drive
DX-NET-SWD 06/13 MN04012009Z-EN www.eaton.com
23
4 Commissioning
4.1 DX-NET-SWD3 with DC1 variable frequency drive
For SmartWire-DT operation, the parameter P-12 must be set on variable
frequency drive DC1; versions 9 - 13 are available for this purpose.
Other parameters do not have to be set.
￫
Complete all measures for commissioning the DC1 variable fre-
quency drive as described in the manual MN04020003Z-EN.
￫
Check the settings and installations for the connection to the
SmartWire-DT system which are described in this manual.
NOTICE
Make sure that there is no danger in starting the motor.
Disconnect the driven machine if there is a danger in an incorrect
operating state.
￫
The following parameter settings listed below are required for
operation with SmartWire-DT.
Valule P-12 Description
0 Control signal terminals
1 HMI device (Keypad FWD)
2 HMI device (Keypad FWD/REV)
3 Modbus with internal ramp time
4 Modbus with ramp time via bus
5 PI controller with external actual value
6 PI controller with external actual value and totalized value of AI1
7 CANopen with internal ramp time
8 CANopen with ramp time via bus
9 SmartWire-DT operation with setpoint value via SmartWire-DT
10 SmartWire-DT operation with local setpoint value
11 Local operation with setpoint value via SmartWire-DT
12 Actuation via SmartWire-DT - depending on the settings with the loss in
communication, automatic change to the local actuation
13 Operation and setpoint value via SmartWire-DT with enable via terminal
￫
Further information about parameter P-12
￫ Section 4.4.3.2, “PNU928/P-12“.