EATON
wb-xp2-en
3
Installation
Busbar
The Busbar Sections are secured to a framing system, such as Unistrut®, using the
Fixing Brackets as shown to the right. The bar can be secured both on its fl at and on
its edge.
Before lifting a Busbar Section, ensure that a detailed risk assessment is carried out
for the lifting procedure being performed in that specifi c area.
Eaton recommend that the fi xing brackets must be mounted no more than 500mm
from the centre of the joints. For vertical riser installation of sections greater than 2
metres it may be easier to lower the Busbar trunking from the fl oor above where it is
to be installed or from a fi xing on the ceiling of the same fl oor if at the end of the run.
Care is to be taken not to damage ends of the trunking when raising from horizontal
to vertical position.
Edge
Flat
Max 50
0mm
Max 50
0mm
This image shows how to lift a
Busbar section vertically.
275
±1mm
Summary of Contents for Power Xpert XP2
Page 8: ...EATON wb xp2 en 8...
