Eaton i-onEX Series, Administrator'S And User Manual

Page: 30 / 116

3. Setting and Unsetting i-on40 & i-onEX Range
Page 24
Partitions to which you have
access.
Note that the installer may have
given the Partition a name, for
example “Stores”. this will appear
on the display instead of the
partition number.
e. Press

or

to select the
change you want for the Partition.
“U>P” = change to Part Set.
“U>S” = change to Full Set.
“S>U” = change to Unset
“P>U” = change to Unset

↕


Note: If a Partition is Full Set then you
cannot go directly to Part Set.
You must unset the Partition
first. If the Partition is Part Set
then you cannot go directly to
Full Set. You must unset the
Partition first.
f. Press

.
Go to: 3. Finishing Setting below.
3. Finishing Setting
Depending on how your installer has programmed your system, you will
need to take one of the following actions to complete setting the system.
Note that you will need a special button fitted in order to use Exit Terminate
Set, and a special lock fitted to use Lock Set.
Instant Set/Silent Set:
Note: Make sure you are outside the
protected area before taking the
next step. Instant set does not
have any exit time.
a.
The keypads give a double “beep”
and the system sets immediately.