i-on40 & i-onEX Range
1. Introduction
Page 11
Grade 3 system access codes are six digits long, providing a total of
1,000,000 different codes, from “000000” to “999999”.
When delivered from the factory the control unit recognises just one user,
and this user has Master User privileges (see page 9).
In Security Grade 2 the Master U
ser’s default access code is “1234”; in
Security Grade 3 it is “123456”. By default the master User does not have
any tag or other device registered to their account.
Eaton’s Security Business recommends that you change the default
access code as soon as possible
(see page 40).
Codes 0000 (or 000000) to 9999 (or 999999) are available but
Eaton’s
Security Business recommends that you avoid easily memorised codes
such a 0000, 999999 or 654321.
The installer has their own access code which they cannot use to set or
unset the alarm system. Neither can they use that code to change details of
other users registered to the system. Similarly, the Master User code has
no access to any installer programming menus and cannot be used to edit
the Installer code.
Proximity Tags
A proximity tag is a small plastic token with a low powered radio transmitter
inside. Each tag contains a unique identity code. (There are 4,294,967,296
(2
32
) different tag identity codes.) Inside the keypad is a sensor. When you
present the tag within about 10mm of the front of the keypad, the control
unit senses the presence of the tag and reads its identity code.
If a user presents a tag that the control unit recognises then the control unit
allows the user to access the system in the same way as if they had keyed
in a recognised access code.
Please note
: the KEY-K01 keypad does not have a proximity tag sensor.
You cannot use proximity tags with this keypad. Ask your installer what
type of keypad is installed in your system.
Code Lockout
If a user has problems remembering their code, or has acquired an
unrecognised tag, they may try keying in their code or presenting the tag
several times. If this happens four times in a row then the control unit locks
all
keypads for 90 seconds and starts a tamper alarm. Once the 90
seconds is finished then the keypads will allow users to try once again. If
the user gets it wrong again then the keypad will lock them out for a further
