Introduction
Page 7
External radio sirens/strobes
Radio siren/strobe units can communicate directly to the control unit using a radio link. The
SND-REXT external radio siren/strobe units is supported.
Note:
It is possible to connect a wired external siren/strobe unit to one of the control unit's
outputs. However, the siren/strobe unit will need a backup power supply, since the control
unit does not provide a 12Vdc output when there is a mains failure.
Internal radio sounders
An internal radio sounder indicates alarms, entry tones, exit tones and other conditions. An
internal radio sounder is intended for use in areas that are out of audio range of the control
unit's built-in sounder, but where users need to hear system sounds.
The SND-RINT internal radio sounder is supported.
Cameras
You can configure the system to store images from a network camera when an alarm
occurs. The following network cameras are supported:
CAM-INT-00
Internal box camera wired/Wi-Fi.
CAM-EXT-00
External bullet camera wired/Wi-Fi.
A micro-SD card is required to store the camera images.
Caution:
To avoid damaging the card, follow the procedure given on page 114 when
removing the micro-SD.
Remote controls
A remote control allows the system to be set or unset using a keyfob (similar to a device
for locking/unlocking a vehicle).
The following devices are supported:
i-FB01
Remote control.
FOB-2W-4B
2-Way remote control.
One-way radio keypad (i-RK01)
In addition to the built-in keypad, the system can have a one-way radio keypad (i-RK01),
which can be used to set or unset the system. The keypad is battery-powered and has a
built-in proximity reader. The keypad has no display, and therefore cannot be used to
configure the system.
Other supported radio devices
The following additional radio devices are also supported
DET-RSURV01
Radio Site Survey Tool.
770REUR-00
Wireless Accessory Module (WAM).
762REUR-00
Radio receiver.
768REUR-00
Radio receiver.
