System Options Menu
Page 73
Tamper
With system set or unset, the control unit starts a tamper alarm and notifies the ARC
with a “Supervision” message.
If Tamper as Tamper Only is set to Disabled (page 66), any outputs of type RF
Supervision or RF Fault activate. If the system is unset, outputs of type Jamming also
activate. See page 66. If there is no Tamper channel allocated in Fast Format, the
system sends an unconfirmed alarm.
Note that the
Tamper
option is required in Grade 2 systems to comply with PD6662.
Note:
If you choose
Tamper
and also set
System Options
– User Reset – System
Tampers
to No, the user will not be able to reset the system after a loss of
supervision event.
Jamming
This specifies the action the control unit should take when it detects jamming radio signals.
Off
The control unit takes no action, irrespective of whether the system is set or unset.
Fault
With system set, the control unit logs the event, but does not display any alert or give
a fault tone. With system unset, the control unit displays an alert, sounds a fault tone
and logs the event.
Tamper
With system set or unset, the control unit starts a tamper alarm and notifies the ARC
with a “Jamming” message.
If
Tamper as Tamper Only
is set to Disabled (page 66), any outputs of type RF
Jamming or RF Fault activate. See page 66. If there is no Tamper channel allocated
in Fast Format, the system sends an unconfirmed alarm.
Note that the Tamper option is required for PD 6662:2010.
Note:
If you choose Tamper and also set
System Options
– User Reset – System
Tampers
to No, the user will not be able to reset the system after Jamming event.
Force Set
You may wish to allow a user with a remote control to set the alarm system when one or
more of the detectors are not working or are active.
Note:
If you enable Force Set, the system does not comply with EN50131.
Off
The remote control user cannot force set the system, even if you have applied the
force set zone attribute to any zones.
Confirm
The remote control user can force set the system by pressing the appropriate button
on the remote control, and when the system does not set, press it again to confirm
setting.
On
The remote control user can force set the system by pressing the button on the
remote control only once.
Note:
The Confirm and On settings also allow a user with a remote control to set the
system if a reset is required after an alarm. If any user is attempting to reset the system
