Getting Started
Page 15
Code lockouts
If you (or any user) enter your code incorrectly or present an unrecognised proximity tag,
the display shows the time and date again, gives an error tone and you can try again.
If there are four consecutive incorrect access codes or proximity tags, the system starts a
tamper alarm and locks out all users for 90 seconds. This event is recorded in the log as
“Excess Keys Tamper”.
Once the lock-out time has expired, you can try again. If the next attempt is also invalid,
system locks for another 90 seconds, but will not start another tamper alarm.
An “Excess Keys Tamper” can also occur while attempting to gain access from the web
interface.
Using Downloader or the web interface
This manual describes configuring the control unit from the control unit. You can also
program a control unit using either of the following:
The web interface, through a web browser. The i-on Web Browser Interface Setup
Guide explains how to configure the system using the web interface. Optionally, you
can access the web interface through the Eaton SecureConnect web portal, as
described in the SecureConnect Installer’s Guide.
The Downloader software running on a PC. This can connect to the control unit via
the PSTN, USB or Ethernet port. Downloader is available to registered users
through
The settings and options provided through the web interface or Downloader have the
same behaviour as those provided through the control unit.
Before you can use the web interface or Downloader, the Master User must enable remote
access using
U
ser
Menu
– System Config – Facilities On/Off – Remote Access
. If remote
access is denied, the Master User can still start a call out to Downloader.
Exiting the Installer menu
To exit the Installer menu:
1.
Replace the lid of the control unit or other devices (if you removed them) to close all
tamper switches.
2.
Press
until the display shows:
Leave
installer mode ?
3.
Press
to leave Installer menu. (Press
if you do not want to leave the menu.)
Note:
You must rectify faults (for example, the lid of the control unit is open) or delete
the device from the system before you can leave the Installer menu.
On completion, the display shows the time and date, and the system is ready for use.