26
27
INM MTL9373-FB3 Rev 1
INM MTL9373-FB3 Rev 1
5. When the enclosure is fitted with a fully bolted lid the enclosure may be
mounted in any orientation but it shall be on a flat surface and care is required
in the installation process to ensure that the enclosure does not distort.
6. All Conditions for Safe Use that are present on the certificates for the glands
and blanking plugs must be observed.
8.4 Inspection and maintenance
a) Inspection and maintenance should be carried out in accordance with
European, national and local regulations which may refer to the IEC standard
IEC 60079-17. In addition, specific industries or end users may have specific
requirements which should also be met.
c) Maintenance of internal components while powered is limited to those
actions permitted in Section 5 of this manual.
8.5 Repair
This product or any of its ancillary fittings cannot be repaired by the user and must be
replaced with an equivalent certified product.
8.6 Marking
Each barrier is marked in compliance with the Directive and CE marked with
the Notified Body Identification Number. This information applies to products
manufactured during or after the year 2019.
For full certification information visit Eaton’s MTL products website at :
www.mtl-inst.com/resources/datasheets
Search on the product family name and type number to view datasheets and
certificates.
Compact Fielbus Barrier assembly marking (without TP32 fitted)
Compact Fielbus Barrier assembly marking (with TP32 fitted)
