Oslostrasse 5, CH
–
4023 Basel
Tel. +41 [0]61 333 70 33, Fax +41 [0]61 333 70 32
www.easyrain.net [email protected]
Brunner Bewässerung - Arrosage
Gebrauchsanweisung Steuerung ESP-TM
4
The ESP-TM series controllers have a backup, or default,
program that takes over if your program is lost because of an
extended power outage.
When the default program is running, all stations revert to
Program A, with 10 minutes of run time per station. The default
starting time is 8:00 AM.
The default program will water every day if the Schedule Slide
Switch is set to "Custom."
If the Schedule Slide Switch is set to one of the fixed
intervals, the default program will run every two, three,
or five days, depending on where the switch is set.
The Program A default settings will be in operation until you
enter your desired settings for Program A. As you enter your
settings in Program A, the default settings are pushed into
reserve status as a backup program. If you are using only
one of the two programs, make sure you use Program A.
Your ESP-TM controller is an electronic clock that controls when
your sprinkler system turns on, and how long the sprinklers run.
Programming is the process of telling the controller exactly when
and how long you want to water. The controller opens and closes
the remote control valves according to the program you set.
Each program contains: Watering days - the specific
days of the week on which watering takes place (for
example,
Default Program
PROGRAMMING THE CONTROLLER
Monday, Wednesday, Friday), or the watering interval
(for example, every third day).
Start time - the time of day that the program begins; this
is the time that the first station in the program begins
watering; all other stations then follow in sequence.
Run time - the number of minutes that each station runs.
ESP-TM Installation and Operation
Page 5
Fill out Program Schedule Sheet
Select watering schedule
Set the current time
Set the current day
Select the program (A or B)
Set station watering days (custom
schedule only)
Set station run times
Set watering start times
Set controller to automatic operation
page 7
page 10
page 11
page 12
page 14
page 15
page 16
page 17
page 19
Programming Checklist
To program the ESP-TM controller for the first time, we
recommend that you complete the following steps in order:
ESP-TM Installation and Operation
Page 6
