Oslostrasse 5, CH
–
4023 Basel
Tel. +41 [0]61 333 70 33, Fax +41 [0]61 333 70 32
www.easyrain.net [email protected]
Brunner Bewässerung - Arrosage
Gebrauchsanweisung Steuerung ESP-TM
10
Set Watering Start Times
Make sure the program you want appears in the
display. Either "PGM A" or "PGM B" will appear.
To switch to the other program, press the A / B
(or PGM) button.
Turn the dial to 1 in the "Watering Start Times"
section.
The display shows the start time currently set for
this program section.
Each program on the ESP-TM can have up to three
watering start times, which tell the controller when to
begin the watering program. The start time applies to all
watering days for that program.
If you want to water more than once a day, you can set
the second and third watering start times. For example, if
you are growing new lawn seed, you might want to water
several times a day. To do so, you could set a program to
run at 6:00 AM, 11:00 AM, and 4:00 PM.
1
2
3
ESP-TM Installation and Operation
Page 17
If you want to set additional start times for this program, move
the dial to 2 or 3 in the "Watering Start Times" section. Then
repeat steps 3 and 4.
If you are following the programming checklist on page 6, you
have now completed all programming steps for Program A.
At this point, you may:
Enter Program B by following the steps that
begin on page 14, or
Set the controller to automatic operation, as
described on page 19.
4
Press or to change the start time. The time setting
moves forward or backward in 15-minute increments.
To eliminate a start time, press or until the blank
setting between 11:45 PM and 12:15 AM appears.
ESP-TM Installation and Operation
Page 18
5
