26
2 Inputs “EQUATOR” with On / Off & High / Low hand held remote control.
Your remote control (ERW-S & ERW-R) has been pre-programmed to work with your heater.
Ensure that the “Manual / Remote” switch on the heater is in the “Remote” position.
To turn the heater on depress and hold for 5 seconds the green “on” button labelled “1”. To turn the
heater off depress the grey “off” button labelled number “1”
To switch from high to low on your heater slide the switch labelled 1, 11, 111 & 1V to the “11”
position. Depress the green “on” button to go to the high input (40,000 BTU) and the grey “off”
button to go to the low input (30,000 BTU)
Buttons 2,3,4 will be inoperative. They can be used to control additional heaters in future. The “G”
button will control a group of heaters.
Always leave the sliding control labelled 1, 11, 111 @ 1V in the “1” position to control on/off and
the “11” position to control high / low.
Positions “111” and “1V’will be inoperative.
Do not change the setting on the reverse side of the remote.
If the remote control becomes inoperative, ensure that there is a fresh battery installed. If you
suspect that the remote may require reprogramming contact the manufacturer for instructions.
To operate the heater manually, turn the “Manual / Remote” switch to “Manual”. In this position the
hand held remote will not operate.
