Easy-Laser XT11, User Manual

Page: 47 / 81

MEASURE USING CONTINUOUS SWEEP
Automatic recording of measurement values during continuous sweeping of the shaft.
There is no limit on the number of points.
Preparations
Before you start measuring, make sure you have done the preparations you need.
l
Mount the measuring units. "Continuous sweep" is available when you use XT60 measuring units.
l
To calculate results, you need to enter at least the distance between the measuring units, see "Enter distances"
on page 36.
l
Connect measurement units.
l
If needed, perform a rough alignment. See "Set up measuring units" on page 34.
l
If needed, measure Softfoot. See "Softfoot" on page 37.
Measure
It is possible to switch measuring method before you have registered a value.
1. Tap on the tab to select the method Continuous sweep.
2. Adjust laser to the center of the targets. If needed, adjust the units on the rods, then use laser adjustments knobs.
3. Tap to start the measurement.
4. Turn the shafts. Turn the shafts as much as possible for a more accurate result.
5. Tap to stop the measurement.
6. Tap to go to the Result view, or tap to measure again.
The registered values are saved when you leave the Measure view. If you return to the Measure view, it is possible to
do a new measurement.
A. Tap to display detector information.
B. Yellow area is where points have been registered.
C. Measurement direction. If you change direction during the measurement, the arrow turns red.
D. Quality assessment. See "Quality assessment" on page 52
E. Tap to display detailed information.
F. Tap to start and stop the measurement.
Make a new measurement. This makes it possible to check the repeatability of the measurement.
Measure using EasyTurn™.
47
HORIZONTAL