Easy-Laser XT11, User Manual

Page: 80 / 81

Easy-Laser AB confirm, that our products are produced according to applicable national and international regulations
and standards. All components are checked before assembly and final products are tested in functionality and visually
checked before delivery
The calibration of the equipment fully complies with ISO9001: 2008 #7.6
Copyright
© Easy-Laser AB 2017
We might change and correct the manual in later issues without further information.
Changes to the Easy-Laser® equipment may also affect the accuracy of the information.
Disclaimer
©Easy-Laser AB 2017
Easy-Laser AB and our authorized dealers will take no responsibility for damage to machines and plant as a result of
the use of Easy-Laser® measurement and alignment systems.
Warranty
NOTE! Before delivery of the product for warranty repair, it is the responsibility of the buyer to backup all data.
Data recovery is not included in the warranty service and Easy-Laser AB is not responsible for data that may
be lost or damaged during transit or repair.
Limited warranty
This product is manufactured under Easy-Laser AB’s strict quality control system. Should the product fail within three
(3) years from the date of purchase under normal usage conditions, Easy-Laser AB will repair or replace the product
free of charge.
1. Using new or refurbished replacement parts.
2. Exchange the product with a product that is new or which has been manufactured from new or serviceable used
parts and is at least functionally equivalent to the original product.
Proof of purchase date should be confirmed, and sent together with a copy of the original purchase document.
Warranty is valid under normal usage described in the user’s manual appended with the product. The warranty com-
prises failure on Easy-Laser® product that could be related to material and/or fabrication errors. The warranty is valid
only in the country of purchase.
The warranty is not valid in the following cases:
l
If the product is broken due to mishandling or incorrect operation
l
If the product has been exposed to extreme temperature, calamity, chock or high voltage.
l
If the product has been modified, repaired or disassembled by unauthorized personnel.
Lithium Ion battery limited warranty
Lithium ion batteries inevitably lose power during their lifetimes, depending on usage temperatures and the number of
charging cycles. Therefore, the internal rechargeable batteries used in the E-series are not included in our general 2-
year warranty. There is a 1 year warranty for the battery capacity not to fall below 70 % (a normal change means that
the battery must have more than 70 % capacity after more than 300 charging cycles). A 2 year warranty applies if the
battery becomes unusable because of a manufacturing fault or factors that Easy-Laser AB could be expected to have
control of, or if the battery displays abnormal loss of capacity in relation to use.
Safety precautions
NOTE! Opening the laser units can result in hazardous radiation, and will invalidate the manufacturer war-
ranty.
80
LEGAL NOTICE