Easy-Laser XT11, User Manual

Page: 36 / 81

Enter distances
Tap any distance input field to enter distance. The field is zoomed in and the keyboard is displayed.
A. Distance between S-unit and M-unit. Measure between
the rods.
B. Distance between S-unit and center of coupling.
C. Distance between M-unit and feet pair one. It is pos-
sible to enter a negative value here.
D. Distance between feet pair one and feet pair two.
Required distances
It is possible to skip all distances and go directly to Measure view. If you change a distance later on, the result is recal-
culated.
l
To calculate an offset and angle result, you need to enter at least the distances between S and M.
l
Feet values can only be calculated if you have entered the distance between the feet pairs.
Coupling diameter
If you want the result based on the gap of the coupling instead of angle, it is necessary to enter the coupling diameter.
The coupling diameter is visible in the report.
1. On the coupling, tap .
2. Tap .
3. Enter the diameter.
Enter Coupling diameter
Gap
To show the result as gap, tap and .
36
HORIZONTAL