INSTALLATION INSTRUCTIONS
28
February 1996 – 1C7836
Connecting the Drains
Warning
• Drains must be made of chemically resistant, non-corrosive material. Use PVC or the equivalent. Do not use
copper or brass.
• The drain must have a minimum diameter of 7.6 cm (3 in.) and be free of obstruction.
• Drain service must comply with all local codes.
• Do not make a solid connection between the HOSES and the drain.
Important
• The floor drain must be within 150 cm (60 in.) of the PROCESSOR.
• The drain must not be higher than 30 cm (12 in.) above the bottom of the PROCESSOR.
Important
Any restriction such as a kinked HOSE can cause the draining wash water to move back into the WASH TANK and
the water to overflow. REINFORCED HOSE, which will not kink, and right-angle ELBOWS for entering the drain are
available from Service Parts Management. If necessary, order the following parts:
• 696442 - REINFORCED HOSE,
5
/
8
in. ID, order by the foot
• 1C4521 - ELBOW,
5
/
8
in.
• 696441 - REINFORCED HOSE, 1 in. ID, order by the foot
• 1C4524 - ELBOW, 1 in.
