EASTMAN
Form C-1572
5. Press the lever (Figure 3, E) to a neutral position and
raise the sharpener to the top (original) position.
6. Remove the four hold-down nuts (Figure 3, V), unplug
solenoid cord and remove the sharpener.
Note:
If you press the sharpener lever (Figure 3, E)
down too far (beyond the neutral position), it will lock
the sharpener bracket. If this occurs, lift the release
lever (Figure 3, D) and start over again.
D release lever
E
sharpener lever
V
hold-down nut
X
plate bolt nut
Figure 3. Removing the Sharpener
Replacing the Rubber Driver Pulley
The sharpener is driven by a rubber driver pulley, as shown
in Figure 4. Replace this driver pulley whenever it appears
to be worn or damaged, as follows:
1. Remove the sharpener from the machine (see
Remov-
ing the Sharpener
on page 5).
2. Press the sharpener lever (Figure 3, E) to a neutral
position and lower the sharpener until an inch of the
square shaft (Figure 4, W) is exposed.
W square shaft
Figure 4. Replacing the Rubber Driver Pulley
3. Hold the square shaft with a wrench. Position the
wrench as close as possible on the shaft to the sharp-
ener housing.
4. Use a spanner wrench to remove the driver pulley
by turning it clockwise as indicated by the arrow in
Figure 4.
Note
: The pulley has a left-hand thread.
5. Reassemble the new pulley on the sharpener.
6. Reassemble the sharpener on the machine.
BACK GUIDE
X
6
