RACKS and CROSSOVERS
5B6331 – 01JUN99
23
Adjusting the GUIDE SHOE on the DRYER RACK
[1] Remove parts as necessary from the DRYER
RACK to obtain access to the bottom GUIDE
SHOE ADJUSTMENT SCREWS.
[2] Remove ROLLERS and AIR TUBES as
necessary to be able to measure the clearance
between the GUIDE SHOE and the “F” ROLLER.
[3] Loosen the GUIDE SHOE ADJUSTMENT
SCREWS.
[4] Set the distance between the “F” ROLLER and the
GUIDE SHOE:
(a) Place a 2.70 mm (0.105 in.) FEELER
GAUGE between the “F” ROLLER and the
long edge of the GUIDE SHOE.
(b) Hold the GUIDE SHOE against the FEELER
GAUGE and tighten the GUIDE SHOE
ADJUSTMENT SCREW.
Important
The clearance along the length of the GUIDE SHOE
and the ROLLER must be uniform.
[5] Check that the adjustment has not changed. The
clearance must be:
2.70 to +/- 0.10 mm
(0.105 to +/- 0.005 in.).
[6] Check for correct operation of the DRYER RACK by running 35 x 43 cm (14 x 17 in.) films.
[7] If the DRYER RACK bottom GUIDE SHOE causes scratching or stubbing of the film, make the following
adjustments as necessary:
Note
Make the adjustments in small increments of approximately 0.10 mm (0.005 in.) to prevent scratching or stubbing of
the film.
(a) If scratching occurs, increase the distance between the bottom GUIDE SHOE and the “F” ROLLER.
(b) If stubbing occurs, decrease the distance between the GUIDE SHOE and the “F” ROLLER.
(c) Check for correct operation of the PROCESSOR.
Adjusting the DRIVE CHAIN
Important
• The RACK must be in solution at operating temperature before you begin this procedure
F
H150_0212GA
ADJUSTMENT SCREW
GUIDE SHOE
(0.105 in.)
2.70 mm
gap:
H150_0212GCA
