EAE EE-C18E, Installation, Operation, And Parts Manual

Page: 20 / 40

Installation, Operation and Parts Manual
EE-C18E
20
5.2 Operation instructions
To avoid personal injury and/or property damage, permit only trained and qualified personnel to operate the lift. After
reviewing these instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on
lift. Always lift the vehicle using all four adapters. Never raise just one end, one corner or one side of vehicle adapters.
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be midway between adapters and centered over the
lift.
1. Park the vehicle between two posts.
2. Adjust the lifting arms until lifting adapters are under the pick ‐ up positions of the vehicle and make sure the gravity of vehicle located
over the center of four lifting arms.
3. Turn on the main power switch and push the”UP”button on the control box until lifting adapters have touched the pick ‐ up positions of
vehicle.
4. Keep on raising the vehicle making its wheels have a bit clearance off the ground and check again the stability.
5. Raise the vehicle to the excepted height, push the LOCK button to engage the mechanical safety locking unit. Check again the stability
before doing maintenance or repair work underneath.
Lowering
When lowering the lift pay carefull attention that all personnel and objects are kept clear.
1. PUSH the DOWN button.
2. When the lift is fully lowered, position the lift arms and adapters to provide an unobstructed exit before removing vehicle from lift area.
3. Drive the vehicle away.
POS. Name Function
QS Main power switch Control on or off of the main power.
HL Power indicator Indicate power connection.
SB1 UP button Control ascent movement.
SB2 DOWN button Control descent movement.
SB3 APS button Woke with SB2 for direct descent.
SB4 LOCK button Engage the mechanical lock.