SPECIFICATIONS
Page T-1
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions, Dangers and Warnings.
ST SHUTTLE 4/6 E VEHICLE SPECIFICATIONS
** DO NOT use low inflation pressure tires on any E-Z-GO vehicle. DO NOT use any tire which has a recommended
inflation pressure less than the inflation pressure recommended in the Owner’s Guide.
BATTERIES
Eight, 6 Volt Deep Cycle
SPEED CONTROLLER
Solid State continuously variable speed controller
MOTOR
48 Volt DC high efficiency shunt wound, brazed armature, solid copper wind-
ings with speed sensor. 15.2 hp (11.3 kw) at 1600 rpm
TRANSAXLE
High efficiency differential with helical gears, 14.7:1 ratio
BRAKES
Dual rear wheel mechanical, self-adjusting drum brakes. Combination service
/ park brake with automatic parking brake release (accelerator kick-off).
Hydraulic front disc brakes (OPT)
PARKING BRAKE
Dual handgrips, scorecard holder & pencil holder
FRONT SUSPENSION
Leaf springs with hydraulic shock absorbers
REAR SUSPENSION
Leaf springs with hydraulic shock absorbers
STEERING
Self-compensating single reduction rack and pinion
STEERING WHEEL
SEATING
Formed, fabric-backed vinyl covers over cushion foam. Seating for two occu-
pants per front, two occupants at rear seat and two for option
SEATING CAPAPCITY
Rear Facing seat: Operator & 5 Passenger Bed/Stake sides: Operator & 3
Passenger
TOTAL LOAD CAPACITY
1200 lbs. (550 kg)
including operator, passenger, accessories & cargo
SPEED
18 mph (29 kph)
CHASSIS
Welded high yield strength tubular steel with Durashield™ Powder Coat paint
BODY & FINISH
Durashield™ body of automotive quality injection molded TPE (thermoplastic
elastomer). Automotive color coat/clear coat finish
STANDARD COLORS
Black
DASH PANEL
Scuff resistant plastic with 4 drink holders & storage for balls & tees
TIRES
23 x 10.5-12 on Alloy Wheel
TIRE PRESSURE
20 psi (137.9 kPa)*
GROUND CLEARANCE
7.0" (18 cm)
WEIGHT
710 lbs. (322 kg)
OPERATING CONTROLS &
INSTRUMENTATION
Removable key, ’deadman’ accelerator control, direction selector, audible
reverse warning, state of charge meter
BATTERY CHARGER
Powerwise QE™ 48V, 110 - 120 VAC, fully automatic, line compensating, 13
Amp DC output at 48 Volts, 9.5 Amps input, 60 Hz anti-drive away charger/
vehicle interlock, UL Listed, CSA Certified
NOISE
VIBRATION, WBV
VIBRATION, HAV
Sound pressure; continued A -weighted equal to 68 db(A)
The weighted RMS acceleration is .44 m/s
2
The weighted RMS acceleration; less than 2.5 m/s
2
