Page P-4
WEATHER PROTECTION
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions, Dangers and Warnings.
FOLD DOWN WINDSHIELD
Tool List
Qty.
Plastic faced mallet......................................................1
Wrench, 7/16"..............................................................1
Phillips screwdriver......................................................1
Remove protective covering from the windshield (item 2)
(Ref Fig. 2 on page C-4).
Install sash (item 3) on each side of the lower section of
windshield. Using a plastic faced mallet, gently tap sash
to ensure windshield seats properly (See Detail A).
Insert bolt (item 4) through washer (item 5), rubber
grommet (item 6) and existing hole in front strut. Secure
with washer (item 5) and lock nut (item 7) (See Detail B).
Do not over-tighten or squeeze grommet
.
Place bottom section of windshield on rubber grommets
and press the sash, starting at the bottom, onto the front
strut so that it snaps into place (See Details B and C).
Repeat for opposite side of windshield.
Position top grips (item 8) as shown (See Detail D) at top
hole on each side of front strut. Secure with top grip fas-
teners (item 9).
It may be necessary on early production sun tops to drill a 9/
32" hole in front face of both sides of front strut approximately
7" down from top of strut.
Swing the top section of windshield up and secure by
hooking the top grip on each side of strut around the
windshield.
To secure windshield when lowered, press edge of wind-
shield firmly into windshield retainers (See Detail B).
Take care not to warp windshield when raising and low-
ering the top section of windshield.
NOTICE
Fig. 2 Fold Down Windshield
6
5
5
Strut
3
7
4
2
Rubber
Latch
Front of Vehicle
Windshield
Retainer
Strut
8
9
Front of
Vehicle
DETAIL D
DETAIL B
3
Windshield
DETAIL A
Windshield
Strut
3
DETAIL C
