E-line CJ-HDR104, User Manual

Page: 56 / 164

48
4.10 Setting
It is for you to set general, network, event, storage, camera and etc.
4.10.1 Camera
Here you can set audio/video property, camera property and channel name, channel type.
4.10.1.1 Image
For analog channel, the camera interface is shown as in Figure 4-50.

Channel: Select a channel from the dropdown list.

Saturation: It is to adjust monitor window saturation. The value ranges from 0 to 100. The default
value is 50. The larger the number, the strong the color is. This value has no effect on the general
brightness of the whole video. The video color may become too strong if the value is too high. For
the grey part of the video, the distortion may occur if the white balance is not accurate. Please note
the video may not be attractive if the value is too low. The recommended value ranges from 40 to 60.

Brightness: It is to adjust monitor window bright. The value ranges from 0 to 100. The default value
is 50. The larger the number is, the bright the video is. When you input the value here, the bright
section and the dark section of the video will be adjusted accordingly. You can use this function
when the whole video is too dark or too bright. Please note the video may become hazy if the value
is too high. The recommended value ranges from 40 to 60.

Contrast: It is to adjust monitor window contrast. The value ranges from 0 to 100. The default value
is 50. The larger the number is, the higher the contrast is. You can use this function when the whole
video bright is OK but the contrast is not proper. Please note the video may become hazy if the
value is too low. If this value is too high, the dark section may lack brightness while the bright
section may over exposure .The recommended value ranges from 40 to 60.

Chroma: It is to adjust monitor video brightness and darkness level. The default value is 50.
The bigger the value is, the large the contrast between the bright and dark section is and vice versa.

Sharpness: The value here is to adjust the edge of the video. The value ranges from 0 to 100. The
larger the value is, the clear the edge is and vice versa. Please note there is noise if the value here
is too high. The default value is 50 and the recommended value ran ges from 40 to 60.

Image enhance: It is to enhance video quality. The larger the value is, the clearer the video is. But
the noise may become large too.

2D NR: It is to process the noise of the single image. The video may become soft after process. The
larger the value is, the better the effect is.

3D Denoise: it is to process the multiple-frame (at least two frames). It is to use the frame
information between the following two frames to reduce noise. The larger the value is, the better the
effect is.