1
E-flite Sobré 3D Profile Assembly Manual
2. Install the elevator micro control horns at this time.
Make sure the rudder horn extends opposite of the
elevator horn.
3. Install the rudder micro control horns at this time as
well. Make sure the rudder horn extends opposite of
the elevator horn.
4. Remove the servo arms from the four servos. Drill
a
1
/
16
-inch (1.5mm) hole in the end of all four of the
servo arms.
Note
: We then suggest using the longest servo arms
available for your servo to help achieve maximum control
throws for 3D flying.
5. Slide a micro control connector into the hole drilled
in the previous step. Secure the connector using a
control connector backplate from the opposite side of
the connector. Repeat for all four servo arms.
Note
: The connectors will face out away from the servo
when installed. Remove any unused sides or portions of
the servo arms.