E-flite Sobré 3D Profile Assembly Manual
Landing Gear Installation
Required Parts
Airframe
Landing gear strut (2)
Wheel retainer (4)
Wheel pant (2)
1.5-inch (38mm) foam wheel (2)
Landing gear support disk (2)
Required Tools and Adhesives
Foam-compatible CA
The landing gear is optional. If you plan on saving
weight, or flying from very rough surfaces, it is suggested
to skip this section.
1. Locate the landing gear strut, two wheel retainers
and the wheel. Use Foam-compatible CA to install
the wheel retainer onto the strut. The retainers will
sandwich the wheel in position.
Note
: Use care not to get CA on the wheel, preventing it
from rotating on the strut.
2. Pass the landing gear through the opening in the
fuselage and wing. DO NOT use glue until instructed
to do so.
3. Repeat Steps 1 and 2 for the remaining strut.