E-flite Sobré 3D Profile Assembly Manual
3. Slide the horizontal stabilizer into the fuselage,
being careful not to damage any of the alignment
tabs. You may need to move the horizontal fuselage
out of the vertical fuselage slightly to get the stabilizer
into position.
Note
: Trim the hinge tape at the rear of the stabilizer to
provide clearance of the alignment hole.
4. Align the wing with the horizontal fuselage.
Use foam-compatible CA to glue the wing to ONLY
the horizontal fuselage.
Hint
: Use the holes for the aileron servos to aid in the
alignment between the horizontal fuselage and wing.
Note
: There are slots at the front and rear of the wing.
Lightly lift the area and apply CA underneath for a
greater gluing area.
Important
: If you plan on using CA activator, make sure
it is foam compatible. Many accelerators will destroy the
foam used on this model.