![background image](http://html1.mh-extra.com/html/blotz/b15-cs-251/b15-cs-251_instructions_2774876001.webp)
15mm Office Block
–
Middle Floor
B15-CS-251
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
We suggest you paint the component parts of your model prior to assembly (see below).
Start by removing the walls and base from the
sprue.
Glue the walls into the base
–
they will extend out of
the bottom of the base by around 2mm.
Take the window pieces.
Using the holes in the base to align them, stick these
inside the walls as shown above.
Take the upper strips.
Glue one to the top of each wall as shown.