5
1.4 Instrument Configuration
•
Remove the instrument from case.
•
Press and hold
FUNC
button while re-inserting instrument into case.
•
Continue to hold
FUNC
button.The display will show 1392, then the Software Version, then
after 2 seconds, the display will show
COnF
.
•
Press the
FUNC
button once. The display will show iP J
•
Use the
UP/DOWN
arrows to select the appropriate input type (eg. 4-20mA, 0-10Vdc, etc).
•
Note: If 0-20mA or 4-20mA is selected, be sure to install the supplied 2.49 ohm resistor
across the V+ and V- terminals.
•
Press the
FUNC
button to store the Input type setting and advance to the next parameter.
•
Using the
UP/DOWN
arrows set the appropriate display units.
•
Press
FUNC
to store the Display Units setting and advance to the next parameter.
•
Using the
UP/DOWN
arrows set the appropriate Decimal Point position.
•
Press
FUNC
to store the Decimal Point setting and advance to the next parameter.
•
Display will alternate between F.S.U. and 10000, use the
UP/DOWN
arrows to set the
appropriate Full Scale Units as specified on the Sensor.
•
Press
FUNC
to store the FSU setting and advance to the next parameter.
•
If further settings need to be modified, refer to Chapter 7 for a full description.
•
Hold the
FUNC
button until display returns to Normal Operation.
•
To set Alarm 1 and 2 thresholds, press the
FUNC
button until 1.Har is displayed.
•
Modify the Alarm 1 threshold by using the
UP/DOWN
arrows until desired value is reached
then press
FUNC
to store and proceed to Alarm 2 threshold.
•
Repeat for Alarm 2 threshold and press
FUNC
to store when done.
•
Secure the instrument in the case by pushing firmly in the bezel until it clicks into the
retaining tabs.
•
The Indicator is now ready for use.