SD-BOX INSTRUCTION MANUAL, CODE: DYN 81.01.00
Date: 03/03/2020
Version 00
- 25 -
Test 6
- Unintended car movement (UCM)
•
Press the “RESET” button.
•
Place the car at floor level with the doors open.
•
Disconnect the floor level signals LEVEL1 and LEVEL2 simultaneously to simulate the car
leaving floor level with the doors open.
•
UCM should be detected when perceiving the level output with doors open.
•
Check the overspeed governor is locked.
•
Check the safety line has opened.
•
Check the fault “F2” appears on the display.
•
Check the LEDs are in the status indicated in the following table:
LED
On
Off
POWER
X
STAND-BY
X
BATTERY CHARGING
X (if the battery is charging)
X (if the battery is charged)
BATTERY FAILURE
X (if the battery is discharged
or not connected)
X (if the battery is charged
and connected)
FAILURE CONFIGURATION
X (if configured to show
system fault at output)
X (if configured to show coil
status at output)
MANUAL RESCUE/BYPASS
X
MANUAL TRIPPING
X
UCM DETECTED
X (Flashing)
DOORS
X
MOTOR
X
LEVEL1
X
LEVEL2
X
INDUCTOR/
μ
SWITCH
X
COIL STATUS
X
•
Reconnect floor level signals.
•
Press the “RESET” button.
•
Check the overspeed governor has been released.
Important
note
If the LEVEL1 and LEVEL2 signals are not switched off
simultaneously, the signal discrepancy error E1 will appear instead of
an UCM being detected and the fault “F2” appearing on the display.
See “
Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer
area in Dynatech’s website in order to consult the full manual; http://customers.dynatech-elevation.com/
Summary of Contents for SD-BOX
Page 2: ......
